Imagine, you have to manage lots of laundry load. But you find your Kenmore washer’s lid locked flashing.
Is it a problem?
Your Kenmore washer lid lock light flashes because the lid lock mechanism is either malfunctioning, obstructed, or the control board detects an error in the locking system.
Table of Contents
How to Fix Kenmore Washer Lid Locked Flashing?
This common issue not only disturbs your laundry routine but also signals something deeper mechanical problems. So, let’s check how to identify and fix them.
Check Door Boot Seal Retaining Ring
Retaining ring secures the door boot seal to the front panel on front load washer. If retaining ring become damaged or missing, door boot seal will be detached from the front panel and the door will not close or lock properly. As a result, you will notice lid lock flashing in your washer. So, check the boot seal retaining ring properly. If it is broken or missing, you must install a new one to fix the problem.
Check Kenmore Washing Machine Lid
If your Kenmore washer’s lid is damaged or misaligned, it will fail to line up with the lock or won’t latch when you close the lid. So, if you notice lid locked light blinking issue in your Kenmore washer, check the lid. If necessary, repair it. Otherwise, you will have to replace it.
Replace Door Boot Seal
A damaged or misaligned door boot seal prevents washer’s door to close or locking properly and shows light blinking issue. So, you should check and replace the door boot seal if necessary.
Check Kenmore Washing Machine Lock
Door lock or lid lock secures your washer’s door or lid during operation. Door or lid must be locked properly otherwise it won’t operate and start blinking. A defective or damaged door lock will prevent washer from spinning or starting. A door lock can fail mechanically or electrically. If it is damaged or fails to latch shut, you should replace it. If your washer fails electrically, use a multimeter and test it for continuity following the wiring diagram of your washer. If the door lock fails to show accurate continuity, replace it.
Replace Washing Machine Door Hinge
Lid strike or door strike is supposed to line up with the lock or latch when you try to close the lid or door. If the lid hinge or door hinge is bent or misaligned, door will not line up properly with the lock or latch. At this time your washer will not lock and your washer’s locked light start flashing. So, inspect the door hinge properly and replace it if required.
Check Washing Machine Door Lock Assembly
A faulty door lock assembly will prevent your washer to lock properly and you will notice locked light flashing. So, check the door lock assembly for any damage and replace it to fix the flashing issue. If there is no physical damage, you should check the continuity with a multimeter. If there is not enough voltage, you must replace the assembly.
Check and Replace Door Latch
A damaged door latch assembly prevents your Kenmore washer from latch shutting properly. So, inspect the door latch assembly properly. If it is damaged, replace it.
Check Door Strike Assembly
If your washer’s door strike assembly fails, you will notice locked light blinking. So, inspect the door strike assembly for any damage. If any damage is notice in the door strike, you must replace it as it is not repairable.
Check Kenmore Washing Machine Control Board
If your washing machine’s lid or door doesn’t close properly, the control board may be defective. But this happens rarely. So, before taking decision of replacing control board, check all the lock mechanism twice. If you don’t find any defect in lock mechanism then you may check the control board and consider to replace when it is defective.
Bottom Line
In above, I have mentioned all possible solutions of Kenmore Washer Lid Locked Light Blinking issue. If you follow the guide one after one, you should be able to diagnose and fix your machine. If problem comes back, you should seek an expert hand for better help.
Leave a Reply